The lug nut matrix design of the spare tire carrier # RM-195225 fits all bolt hole patterns on 16" - 24-1/2" wheels. As a result it will work with the P205/70R15 tire with an 8 lug wheel. view full answer...
For your 2015 Fleetwood Tioga Ranger On the Ford E-450 you will need the Adco Deluxe RV Windshield Cover # 290-2507. The Cover # 290-2509 is for the Chevrolet chassis which the RV is also built on. view full answer...
The install of the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen # 3441409775PBK consists of cutting the rails to the correct length to match door height, inserting the header into the rails and then using included screws to attach rails to wall on either side of door opening. It installs on the inside of the toy hauler. It shouldn't be an issue with the inflatable patio set you have currently. view full answer...
SumoSprings has listed the # SSR-106-54-1 as a fit for your 2015 Fleetwood Tioga Ranger 31A Motorhome so it has been tested and confirmed that it works well. It has the higher capacity like you are wanting which give you more support so this would be a perfect solution.
The install of this kit and the # SSR-106-47-1 is the exact same though so if you wanted to use the install video for the # SSR-106-47-1 as a guide you could. view full answer...
We definitely have a hitch that can install on your 2011 Fleetwood Tioga Ranger 24L, but I do need to mention that not all bike racks are rated for use on an RV. This is primarily caused by two factors, the distance between the rear axle of the RV and the receiver, and the stiffer ride typically experienced in RVs. This causes more shaking and jarring than would be experienced when mounted in the receiver on a passenger vehicle.
With that out of the way, the Curt Adjustable Trailer Hitch... view full answer...
I checked out pictures of the Starcraft ARone travel trailer I found online and it appears to have a 4 inch rear bumper like what the Swagman bike rack # S80600 was designed to fit so this would work well for you. view full answer...
Yes, the SumoSprings Solo Custom Helper Springs part # SSR-130-54 have a shipping weight of 7 lbs. If you need anything else please feel free to let me know. I have attached a review video for you as well. view full answer...
The Go Power Extreme kit part # 34282185 uses like a modular connection that allows to easily add more panels as basically you would just attach an additional connector and that's all you'd need to do. The part # GP22VR is a three panel setup that doesn't have the same room to grow but it accomplishes the same for three panels basically.
If you fastforward to the 14 minute mark of the attached install video you can see what I mean. view full answer...
If the 7-way trailer connector you have was equipped from the factory which it most likely was then all you will need to do is plug in the brake controller and then you are good to go. The plug for your 2010 Ford E-450 chassis should be located up under the dash, near the emergency brake pedal. If you like you can test the pins inside the connector to see if they are active but you should not need to.
I recommend using the Redarc Tow-Pro Elite Trailer Brake Controller part # RED44FR with... view full answer...